hifi engine

Manual Library / Pioneer

Pioneer VSX-456

Audio Video Stereo Receiver

add a review add a review

Pioneer VSX-456


Tuning range: FM, MW

Power output: 100 watts per channel into 8Ω (stereo)

Surround output: 100W (front), 100W (center), 100W (rear)

Frequency response: 5Hz to 100kHz

Total harmonic distortion: 0.09%

Input sensitivity: 2.8mV (MM), 200mV (line)

Signal to noise ratio: 72dB (MM), 96dB (line)

Output: 200mV (line)

Video Connections: composite

Dimensions: 420 x 155 x 374mm

Weight: 9.1kg

Accessories: remote control



re: VSX-456

I can send picture if you still need it. I am trying to 'resurrect' mine!!

re: VSX-456

Any chance you found the VSX-456 owner's manual during the resurrection process? I am searching for it. After moving my system, I cannot figure out how to get the machine out of standby mode. It has happened to me before - and it took a lot of button pushing to get it back into play/active mode. I am hoping there is a solution. My display was dimming terribly last time I used it. Just hoping that is not the issue (i.e. I cannot tell that it is on possibly). STANDBY light is bright and red.

Thanks for any assistance you or someone else may offer.

re: VSX-456

Does anyone have the back panel picture\drawing for the Pioneer VSX 456? I found the service manual but could use the owners manual so I can know the correct way to connect rca plugs and speaker wires. Thanks, Paul M.

re: VSX-456

Have you found the Owners Manual? Looking for one myself.
Mary W.

This website is not affiliated with or sponsored by Pioneer. To purchase VSX-456 spares or accessories, please contact the company via their website or visit an authorised retailer.