hifi engine

Manual Library / Realistic

Realistic STA-16

AM/FM Stereo Receiver (1977)

add a review add a review

Realistic STA-16

Specifications

Tuning range: FM, MW

Power output: 3.5 watts per channel into 8Ω (stereo)

Frequency response: 30Hz to 22kHz

Total harmonic distortion: 0.9%

Input sensitivity: 2.5mV (MM), 150mV (line)

Signal to noise ratio: 60dB (MM), 60dB (line)

Output: 250mV (line)

Semiconductors: 25 x transistors, 21 x diodes, 2 x varistors

Dimensions: 416 x 127 x 270mm

Finish: walnut veneer case

Year: 1977

Price: USD $119.95 (1977)

Downloads

Comments

re: STA-16

The STA-16 replaced the STA-15 in 1977 and sold through 1978, replaced the by the STA-42 in 1979. Made by Tandy Electronics in Korea.

re: STA-16

I purchased one new in 1977. It was our Christmas present to each other. We spend most of our money on speakers. We loved it and operated the receiver until 1995 when it was damaged during a move. I never did figure out what the surround or quad setting was about because I only had two speakers. The amp operated continuously for 18 years until damaged while moving.

This website is not affiliated with or sponsored by Realistic. To purchase STA-16 spares or accessories, please contact the company via their website or visit an authorised retailer.