hifi engine

Manual Library / Rotel

Rotel RX-504

AM/FM Stereo DC Receiver

add a review (1 review)

Rotel RX-504

Specifications

Tuning range: FM, MW

Power output: 40 watts per channel into 8Ω (stereo)

Frequency response: 5Hz to 60kHz

Total harmonic distortion: 0.08%

Damping factor: 35

Input sensitivity: 2.5mV (MM), 150mV (DIN), 150mV (line)

Signal to noise ratio: 78dB (MM), 90dB (DIN), 90dB (line)

Output: 270mV (line), 90mV (DIN)

Speaker load impedance: 4Ω to 16Ω

Dimensions: 430 x 115 x 334mm

Weight: 10kg

Year: 1979

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed Aug 05th, 2015 by Ace G.Vincent.N.Georgiou

A lovely receiver to look at as the music plays.
great quality and very well made, strong and a bit heavy.
Sounds great and loud with 2 12inch speakers 8ohms each and dome tweeters, speaker boxes H/W/D/ 30 inches / 15 inches / 8.5 inches, and each speaker has a 2 inch air hole in the front, the reason im giving detailed info on the speaker is because i went though hell trying to get the best for this amp, i started of with 8 inch 4ohm speakers but the amp did not like them, with the speakers ive got now this amp is pushing out more then 91db @ 1 meter i know the bass is going though the ceiling, and still a heavy warm bass with the volume low, the speakers im using are ones i built, this amp will sound just as good with port speakers / bass reflex, floor standing 91db@1 meter. This is fantastic receiver.

 

Comments

This website is not affiliated with or sponsored by Rotel. To purchase RX-504 spares or accessories, please contact the company via their website or visit an authorised retailer.