hifi engine

Manual Library / Sansui

Sansui 2000A

Solid State AM/FM Stereo Tuner Amplifier (1969-71)

add a review (4 reviews)

Sansui 2000A

Specifications

Tuning range: FM, MW

Power output: 35 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 20kHz

Dimensions: 440 x 125 x 350mm

Year: 1969

Downloads

Related Catalogues

Tuners Amplifiers Receivers

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.

Reviews

 Login or register to post reviews

rating
Reviewed Apr 20th, 2018 by youngdl

Very good sounding lower power receiver. Very competitive contest between it and my Sherwood S-7200 for most pleasurable to listen too after recapping and noisy transistors replaced. Good FM tuner. Also did the Conrad Hoffman mods to it. Both undervalued in the market, particularly the Sherwood. The cap coupled 2000A drives my large Advent Legacy IIs in my living room effortlessly. It does not seem to be lacking in punch compared to the later '70s 45-60 watt per channel designs

rating
Reviewed Apr 26th, 2016 by memofer

I Agree! This is a great receiver, amazing how good it sounds after replacing power supply and amp electrolytics.

rating
Reviewed Apr 05th, 2016 by Frank.W61

Toller Receiver von Ende der 60er Jahre. Warmer weicher Klang. Preislich gl├╝cklicherweise vollkommen unterbewertet.

rating
Reviewed Oct 27th, 2015 by jrcbriones

Really good sounding receiver. I can't believe these are so undervalued. It's really quite lovely.

 

Comments

re: 2000A

Does anyone have a list of the capacitors, transistors, and diodes that should be replaced to bring the 2000A back to it's glory? There's someone on Ebay selling a kit for $165. Is that a good price?

Thanks

re: 2000A

You might find something on Audiokarma.org in the Sansui section. Do some searches there. Otherwise make your own list based on what is on your circuit boards. Stick with same capacitance values but can go up in voltage if need to, just not down. Build a list on Mouser.com. Use Audio Grade in the signal path. Just about all new caps will have better specs than originals. Stick with Nichicon & Elna Silmic II.

re: 2000A

I would like to acquire a complete set of tubes to replace the old ones. these ones have been in since 1971.
does anyone know where I may purchase these?

re: 2000A

Maybe you have a Sansui 1000 ?

re: 2000A

The Sansui 2000A is a solid state receiver. There are no tubes.

Perhaps you mean the 200A.

This website is not affiliated with or sponsored by Sansui. To purchase 2000A spares or accessories, please contact the company via their website or visit an authorised retailer.