hifi engine

Manual Library / Sansui

Sansui 300

Solid State AM/FM Tuner Amplifier (1970)

add a review add a review

Sansui 300


Tuning range: FM, MW

Power output: 14 watts per channel into 8Ω (stereo)

Frequency response: 25Hz to 30kHz

Total harmonic distortion: 1%

Damping factor: 20

Input sensitivity: 3mV (MM), 180mV (DIN), 180mV (line)

Signal to noise ratio: 65dB (MM), 70dB (line)

Channel separation: 40dB (MM), 45dB (line)

Output: 180mV (line), 30mV (DIN)

Speaker load impedance: 4Ω to 16Ω

Semiconductors: 36 x transistors, 1 x FET, 2 x varistors, 1 x thermistor, 18 x diodes, 1 x zener diode

Dimensions: 15-7/8 x 4-9/16 x 11-1/16 inches

Weight: 21lbs

Year: 1970



re: Sansui Solid State 300

I found one of these in the garbage. Fixed two broken wires and new LED bulbs... now looks not to bad and sounds great! It's a nice build for 1970.

This website is not affiliated with or sponsored by Sansui. To purchase 300 spares or accessories, please contact the company via their website or visit an authorised retailer.