hifi engine

Manual Library / Sansui

Sansui SC-3003

Stereo Cassette Tape Deck (1977)

add a review add a review

Sansui SC-3003

Specifications

Type: 2-head, single compact cassette deck

Track System: 4-track, 2-channel stereo

Tape Speed: 4.8 cm/s

Heads: 1 x record/playback, 1 x erase

Motor: electronically controlled DC

Tape Type: type I, CrO2

Noise Reduction: B

Frequency Response: 30Hz to 16kHz  (Cr02 tape)

Signal to Noise Ratio: 60dB  (dolby B)

Wow and Flutter: 0.09%

Input: 70mV (line), 0.5mV (mic)

Output: 0.3V (line)

Dimensions: 441 x 158 x 290mm

Weight: 8kg

Year: 1977

Downloads

Comments

re: SC-3003

Mech is identical to that used in AKAI CS-707D!
Note to anyone servicing these. The counter belt must be in fairly good shape to actuate the motion sensor, or the deck shuts off.

It takes a rather convoluted path from the tape counter and motion sensor (front LH side) , round the TU reel table and also round a small rotary guide low down in the well.You can get better fast wind performance if you just replace with a shorter belt, and thread it round the supply spindle and then out to the counter /sense pulleys. The angles are less acute that way. Whichever way you choose, the belt must be fairly loose - just tight enough to move the two pulleys - otherwise there'll be too much drag on the motor. HTH.

re: SC-3003

Hi,

Can you illustrate in a drawing or a image?

Hoping for help :)

This website is not affiliated with or sponsored by Sansui. To purchase SC-3003 spares or accessories, please contact the company via their website or visit an authorised retailer.