hifi engine

Manual Library / Sharp

Sharp SM-5100H

Stereo Integrated Amplifier

add a review (1 review)

Sharp SM-5100H

Specifications

Power output: 33 watts per channel into 8Ω (stereo)

Frequency response: 10Hz to 65kHz

Total harmonic distortion: 0.01%

Damping factor: 50

Input sensitivity: 2.8mV (MM), 150mV (line)

Signal to noise ratio: 75dB (MM), 90dB (line)

Output: 150mV (line), 30mV (DIN)

Semiconductors: 3 x IC, 14 x transistors, 2 x FET, 12 x diodes, 11 x LED

Dimensions: 430 x 75 x 382mm

Weight: 8kg

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed Sep 10th, 2014 by guest

Sharp engineers have had free hands to develop fine sounded slim line amps.

 

Comments

dopiereit's picture

re: SM-5100H

I have one second hand for free. It powers up but shuts of in a few minutes. I hear the speaker relais clicking but don't know what the problem can be. I found at least 1 exploded capacitor wich was solderd on the on/off switch, so i replaced that. But anyone has an idea what this might be?

Edit: i saw the soldering on the power amp block's were bad. so i resoldered every tip of the two power blocks and pre amp. The i cleaned the whole print and powerd up the amp... Problem solved!

This website is not affiliated with or sponsored by Sharp. To purchase SM-5100H spares or accessories, please contact the company via their website or visit an authorised retailer.