hifi engine

Manual Library / Sherwood

Sherwood S-6040CP

Stereo Power Amplifier

add a review (1 review)

Sherwood S-6040CP

Specifications

Power output: 100 watts per channel into 8Ω (stereo)

Frequency response: 1Hz to 200kHz

Total harmonic distortion: 0.03%

Damping factor: 90

Input sensitivity: 1V

Signal to noise ratio: 110dB

Speaker load impedance: 4Ω (minimum)

Dimensions: 440 x 110 x 350mm

Weight: 14kg

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed May 24th, 2016 by keilau

The S-6040CP is one of the better sounding power amplifier in the 100W/ch range. I have 3 of them for a 5.1 setup. The basic circuit is from the Hitachi technical note and similar to the Hafler HD-200/220, but with much heavier construction and beefier power supply than the Hafler. It is a dual mono design that weights 31 pound.

Depending on the age and condition, you may want to consider a re-cap of the power supply section. You will definitely need to if you hear hum from your unit. It is normal for old audio equipment. Make sure that there is no DC offset at the speaker output. If you do, correct it with the trim pot VR101L/R. The MOSFET amp usually runs hotter than other bipolar amplifier. If you feel the cabinet is too hot, check the idle current too. All these process can be found in the service manual.

 

Comments

inkel md2200

The same model

inkel md2200

but More good parts in Sherwood S-6040CP

rlisin's picture

re: inkel md2200

Actually Inkel was the manufacturer in all cases, there were at least 2 revisions of this amp (very minor changes), so there could be different components too - but probably not depending on brand, but rather on the production batch or revision.

This amp was sold as: Sherwood S-6040CP, Inkel MD2200, LXI AM4222.

This website is not affiliated with or sponsored by Sherwood. To purchase S-6040CP spares or accessories, please contact the company via their website or visit an authorised retailer.