hifi engine

Manual Library / Sony

Sony STR-AV1070X

AM/FM Stereo Receiver

add a review add a review

Sony STR-AV1070X

Specifications

Tuning range: FM, MW

Power output: 120 watts per channel into 8Ω (stereo)

Surround output: 120W (front), 15W (center), 15W (rear)

Frequency response: 10Hz to 70kHz

Total harmonic distortion: 0.015%

Damping factor: 50

Input sensitivity: 2.5mV (MM), 150mV (line)

Signal to noise ratio: 87dB (MM), 105dB (line)

Output: 150mV (line), 1V (Pre out)

Speaker load impedance: 8Ω to 16Ω

Video Connections: composite

Dimensions: 430 x 147.5 x 350mm

Weight: 12.5kg

Accessories: RM-P311 remote control

Downloads

Comments

re: STR-AV1070X - Front Speaker Outputs Non-Operational

The unit i purchased was used, and their appears to be a problem with it. The "Front" speaker outputs are completely silent. No output whatsoever. Since I have no Schematic, I have no way of tracking back the problem. The "Center" speaker outputs work fine, however their is no mode that will enable the "Front" speaker outputs.

Does anyone have idea as what I can do to repair the unit. I am an electronics tech. and can replace many of the different types of components which might be suspect.

Any hints as to how to go about getting my Amp up and running, would be greatly appreciated.

This website is not affiliated with or sponsored by Sony. To purchase STR-AV1070X spares or accessories, please contact the company via their website or visit an authorised retailer.