hifi engine

Manual Library / Sony

Sony TA-5650

V-FET Integrated Stereo Amplifier (1975-78)

add a review add a review

Sony TA-5650


The Sony TA-5650 is rated at 50 watts minimum RMS per channel with an 8-ohm load from 20-20,000Hz and may deliver an instantaneous peak power much greater than the rated power.

The unit features dual phono inputs (with supplied shorting plugs when not in use) and two tape loops for simultaneous recording or direct tape duplication.

The TA-5650 can also be divided into separate units, pre-amplifier and power amplifier, to connect to other add-on components.

Finally, two pairs of EXT adaptor jacks are provided (one on the front panel and one on the rear) for use with a graphic equalizer, speaker equalizer, SQ adaptor (for quadraphonic sound) or a third tape recorder.


Power output: 50 watts per channel into 8Ω (stereo)

Frequency response: 10Hz to 100kHz

Total harmonic distortion: 0.05%

Damping factor: 50

Input sensitivity: 2.5mV (MM), 150mV (line)

Signal to noise ratio: 70dB (MM), 90dB (line)

Output: 150mV (line), 17mV (DIN), 1V (Pre out)

Speaker load impedance: 4Ω to 16Ω

Semiconductors: 10 x VFET, 9 x FET, 42 x transistors, 31 x diodes

Dimensions: 460 x 168 x 323mm

Weight: 14.1kg

Year: 1975


Related Catalogues

Amplifiers Receivers Tuners


Complete Range


HiFi Stereo Quadro

HiFi and Stereo Cassettes

High Fidelity Components

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


ampli ancien en panne.

Merci pour ce coup de pouce. Reste à réussir le dépannage.


merci pour le manuel

This website is not affiliated with or sponsored by Sony. To purchase TA-5650 spares or accessories, please contact the company via their website or visit an authorised retailer.