hifi engine

Manual Library / Technics

Technics SA-160

AM/FM Stereo Receiver (1988-90)

add a review add a review

Technics SA-160

Specifications

Tuning range: FM, MW

Power output: 40 watts per channel into 8Ω (stereo)

Frequency response: 10Hz to 70kHz

Total harmonic distortion: 0.07%

Damping factor: 20

Input sensitivity: 3mV (MM), 200mV (line)

Signal to noise ratio: 71dB (MM), 85dB (line)

Channel separation: 55dB (line)

Output: 200mV (line)

Speaker load impedance: 4Ω to 16Ω

Downloads

Related Catalogues

HiFi

Product News

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.

Comments

re: SA-160

The solution is to carefully re-solder the output and regulator IC's.

re: SA-160

i have a problem with my sa-160. it turns on normally. the sound isfine and dandy but after random amount of time (sometimes it can be after hour, sometimes just seconds after turning on) the sound disappears. the amplituner works fine beside that. i can change inputs, radio stations and such. and when i turn off and turn on i get the sound back on
any help?

re: SA-160

Another possible solution is to clean the connectors between boards. When I had this problem it turned out to be a poor connection to the tuning board.

re: SA-160

I got the exact same thing with Mine. It also gets a little hot on the top, in the middle, at the back. Did you find a solution?

This website is not affiliated with or sponsored by Technics. To purchase SA-160 spares or accessories, please contact the company via their website or visit an authorised retailer.