hifi engine

Manual Library / Technics

Technics SA-GX490

AV Control Stereo Receiver

add a review add a review

Technics SA-GX490

Specifications

Tuning range: FM, MW

Power output: 80 watts per channel into 8Ω (stereo)

Surround output: 55W (front), 55W (center), 55W (rear)

Frequency response: 10Hz to 40kHz

Total harmonic distortion: 1%

Damping factor: 30

Input sensitivity: 3mV (MM), 200mV (line)

Signal to noise ratio: 80dB (MM), 88dB (line)

Channel separation: 55dB (line)

Output: 200mV (line)

Speaker load impedance: 8Ω to 16Ω

Video Connections: composite

Dimensions: 430 x 136 x 352mm

Weight: 9.2kg

Accessories: remote control

Downloads

Comments

speakers

just wondering, I have an opportunity to pick up this receiver , unfortunatelly, it dosen't come with speakers ....

Any suggestions on a good set of speakers for this particular receiver ?

Boots1917's picture

re: speakers

I have a pair of Polk Audio RTA 11B speakers that I purchased 32 years ago that work like new. Polk Speakers have rubber around the cones instead of foam. Foam can deteorate in as little as 10 years and can be quite expensive to replace. I have purchased several pairs of used Polk bookshelf speakers from Ebay and Craig's List over the years and have been very satisfied. Polk's wattage capacity ranges from 100w to 1000w depending on the receiver or amp you have. Frequency response is excellent on all models and the new Polk's are excellent performers and a good "bang for the bucks" I hope this helps you.

re: speakers

MTX AAL 12B speakers work fantastic the speakers are 100watts RMS/200watt Total and they play on a frequency of 50khz -20khz at 8ohm

This website is not affiliated with or sponsored by Technics. To purchase SA-GX490 spares or accessories, please contact the company via their website or visit an authorised retailer.