hifi engine

Manual Library / Wharfedale

Wharfedale Teesdale SP2

3-Way Loudspeaker System

add a review (1 review)

Wharfedale Teesdale SP2

Specifications

Type: 3 way, 3 driver loudspeaker system

Frequency Response: 40Hz to 26kHz

Power Handling: 40W

Crossover Frequency: 800, 5000Hz

Impedance: 8Ω

Sensitivity: 87dB

Bass: 1 x 200mm cone

Midrange: 1 x cone

Tweeter: 1 x isodynamic

Enclosure: 40 litre, ported

Dimensions: 578 x 340 x 278mm

Weight: 14.1kg

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed Mar 10th, 2019 by anderl1962

Best speakers i bought.

 

Comments

re: Teesdale SP2

I love these speakers. Unfortunately the midrange membranes have been damaged. I can get spares on eBay, but it's not obvious how to remove the old ones. Would anyone have instructions on how to swap out the midrange speakers?

Ditton's picture

re: Teesdale SP2

4 screws, take them out. cut off cable close to the old speaker. observe polarity. get the colours right! tale off 1 cm of insulation. solder new speaker to cable. get some foamtape around the hole, rfix with the old screws. voilĂ !

This website is not affiliated with or sponsored by Wharfedale. To purchase Teesdale SP2 spares or accessories, please contact the company via their website or visit an authorised retailer.