hifi engine

Manual Library / Yamaha

Yamaha CR-1000

FM Stereo Receiver (1974)

add a review (1 review)

Yamaha CR-1000

Specifications

Tuning range: FM

Power output: 70 watts per channel into 8Ω (stereo)

Frequency response: 10Hz to 50kHz

Total harmonic distortion: 0.1%

Damping factor: 70

Input sensitivity: 3mV (mic), 3mV (MM), 150mV (line)

Signal to noise ratio: 70dB (mic), 80dB (MM), 90dB (line)

Channel separation: 50dB (MM), 50dB (line)

Output: 150mV (line), 0.775V (Pre out)

Speaker load impedance: 4Ω to 16Ω

Semiconductors: 2 x IC, 2 x MOSFET, 10 x FET, 98 x transistors, 56 x diodes, 6 x zener diodes

Dimensions: 510 x 174 x 335mm

Weight: 19kg

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed Feb 21st, 2018 by sssboa

Best sound I ever heard and I had loads of vintage and new gear. Bass is insane tight and deep, detail is there, continuous loudness is an amazing feature. Radio tuner is best possible.

Volume potentiometer could be better balanced at low volumes but still 10/10.

Extremely powerful and loud for its rating, you may connect the least sensitive speakers on earth, you may connect two pieces of rock and it will make sound out of them.

 

Comments

re: CR-1000

This is so far best sounding receiver/amp I experienced.

I also have Marantz 2270 but Yamaha CR-1000 is crispier clearer sounding and with bass getting lower. In comparison Marantz 2270 being a good amp in its own right is wooly sounding though with too much middle bass and not enouth lowest frequencies compared to CR-1000. My friends share my views when I present to them both amps (both are recapped).

Compared to later CR-1020 this one has better quality pcbs and runs cooler.

This website is not affiliated with or sponsored by Yamaha. To purchase CR-1000 spares or accessories, please contact the company via their website or visit an authorised retailer.